TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
29
6 Handset Configuration
The VoWiFi Handset requires some settings to function in the VoWiFi system. All settings
are done in the WinPDM/IMS2. This section describes the available settings for the handset.
The first part explains network settings and the second handset settings.
For more information, see the WinPDM Online Help that is accessible for each parameter by
clicking the icon in the Edit parameters view, or the Installation and Operation Manual,
Portable Device Manager (PDM), Windows Version, TD 92325GB.
6.1 Select Network
The handset can switch between four different WLAN system configurations called Network
A, Network B, Network C, and Network D. The name can be changed (via WinPDM or IMS2)
and is visible in the handset, see 6.1.2 Change Name of Network.
A handset can be configured for up to four different WLANs but only for one IMS2 and one
VoIP System.
The configured networks in WinPDM must have a SSID value in order to view them in the
handset.
Network A is the default system and used throughout this manual.
1 Select Device > Settings.
2In the Active network drop-down list, select “Network A”.
6.1.1 Change Active Network
1 Select Device > Settings.
2In the Active network drop-down list, select “Network A", "Network B", "Network C",
or "Network D".
6.1.2 Change Name of Network
The name is shown when selecting network in the handset.
1 Select Network > Network A (or B, C, or D).
2 In the Network name field, enter the name of the network.
6.2 IP Address Settings
The IP address settings can be configured in two ways.
• The handset can configured to receive an IP address automatically from a DHCP server,
see 6.2.1 Automatic IP Address Settings.
• If no DHCP server is used, an unique IP address must be entered manually for each
handset, see 6.2.2 Static IP Address (Manual) Settings.
6.2.1 Automatic IP Address Settings
1 Select Network > Network A (or B, C, D).
2 In the DHCP mode drop-down list, select “Enable”.
The Phone IP address, Subnet mask and Default gateway are automatically set up.
To Next Page
Loading...
