ASCOM I62 - Perform a Factory Reset; Replacement of Handsets; Replacement Procedure Choice

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
21
For example, a license can be moved when there are an unused i62 Talker and an i62
Protector with a broken display. In this case, the Protector license can be moved to the i62
Talker that becomes an i62 Protector. Then the broken handset (that is now an i62 Talker)
can be sent for service.
1 Select the “Licenses” tab.
2 Select the handset whose license to be moved.
3In the License menu, select “Move license...” or right-click handset and select “Move
license...”.
4In the Move license window, select the handset (i62 Talker) that shall receive the
license. Click "OK".
If no handsets are shown, there are no applicable handsets to move the license to.
See also 5.2 Replacement of Handsets on page 21 for information on how to move user
parameters and contacts to another handset.
5.1.8 Perform a Factory reset
When a factory reset is done on a handset, all configuration settings will be restored to
default values; PBX subscriptions, contacts, messages, downloaded language, certificate etc.
will be removed. The software and licenses will be left intact.
Factory Reset using WinPDM
1Open the WinPDM.
2 Put the handset in the DP1 cradle.
3In the Device tab, mark the handset to be facory reset. Note that the handset must be
online.
4 In the Device menu, select "Factory reset". Alternatively, right-click the handset and
select "Factory reset".
5A Reset devices window appears, click "Yes". The handset will be restarted.
Factory Reset using Handset
It is possible to factory reset a handset from its Admin menu.
1 To activate the Admin menu, select Menu > Settings and enter 40022.
2 Select "Factory Reset".
3A Reset portable? window appears, press "Yes". The handset will be restarted.
5.2 Replacement of Handsets
A handset can be replaced with a spare handset if it is broken. The handset registered in
WinPDM or IMS2, is associated with its device type, device ID and extension. During the
replacement procedure, the broken handset’s device type and extension will be associated
with the spare handset’s device ID.
5.2.1 Replacement Procedure Choice
• If you have IMS2 and already have applied the network template to the spare handset(s)
to log on it later on, see 5.2.2 Replacement of Handset with IMS2.