TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
37
The parameter affects the “Normal”, "Headset", "Loudspeaking" mode.
For selection of headset, see Headset on page 37.
Note: Changing this parameter may result in lower sound quality and high sound level.
Evaluate carefully before applying.
Headset
Select the headset model that is used.
1 Select Headset > General.
2 Select the applicable item in the drop-down list:
IMPORTANT: Do not select “Hearing protection” unless a Peltor headset is used.
• Hearing protection
•Mic on boom
•Mic on cable
• User model (If not any headset is used above, this option can be used to configure
an own headset profile. If selected, additional configuration is required, see
Headset User Model)
Headset User Model
These settings are required if User model is selected under Headset > General.
1 Select Headset > User model.
2In the Name of headset field, enter a descriptive name. For example the headset
model to be used.
3 In the following drop-down lists, select the applicable values for the headset:
•Microphone gain
• Speaker gain
•Side tone
Note: Changing the parameters may result in lower sound quality and high sound level.
Evaluate carefully before applying.
6.5.4 Actions when Handset Placed in Charger
It is possible to apply an action for a handset when placing it in a charger.
In Charger Action
1 Select Device > Settings.
2In the In charger action drop-down list, select one of the following:
• No action - no action will be performed when handset is placed in charger
• Switch off - the handset will be switched off when placed in charger
• Sound off - the handset will be silenced when placed in charger
• Change profile - the handset will change profile when placed in charger.
- In the Change profile in charger drop-down list, select the profile to be used.
- If needed, configure the selected profile, see 6.5.5 Configure Profiles.
Clear Lists in Charger
1 Select Device > General.
To Next Page
Loading...
