TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
31
6.3.3 World Mode Regulatory Domain
There is a set of regional rules for the world mode settings and the a-band that the handset
complies to. The preferred and the default setting is “World mode (802.11d)”. The handset
gets its regulatory settings from the AP. If this is not supported by the AP, then this has to
be set in the handset as follows:
1 Select Network > Network A (B, C, or D).
2In the World mode regulatory domain drop-down list, select one of the following:
• World mode (802.11d) (default)
•ETSI
• Japan
•USA
6.3.4 Radio and Channel Selection
The handset supports the 802.11a/n radio and 802.11b/g/n radio, but it cannot use the
802.11a/n radio and the 802.11b/g/n radio simultaneously. The radio determines which
channels that can be used.
802.11 a/n Channels
Defines which 802.11a/n channels to use. It is recommended to use the value "UNII-1".
Select "Advanced" only if the channels shall be set in the Advanced: 802.11 channels
parameter, see Advanced: 802.11 Channels on page 32.
1 Select Network > Network A (B, C, or D).
2In the 802.11 protocol drop-down list, select "802.11a/n".
3In the 802.11a/n channels drop-down list, select one of the following:
Note: The selected World Mode Regulatory Domain determines which channels to be
used. See Bands and Channels used by WiFi a-radio.
•All
•Non DFS
• UNII-1
• UNII-3
• UNII-1, UNII-2
• UNII-1, UNII-2, UNII-3
• UNII-1, UNII-2, UNII-2 Extended
• Advanced
Bands and Channels used by WiFi a-radio
Frequency band Channels
Non DFS 5.150 - 5.250 MHz,
5.725 - 5.845 MHz
36,40,44,48
149,153,157,161, 165
UNII-1 5.150 - 5.250 MHz 36,40,44,48
UNII-2 5.250 - 5.350 MHz 52,56,60,64
UNII-2 Extended 5.470 - 5.725 MHz 100, 104, 108, 112,116, 120, 124, 128, 132,
126, 140
UNII-3 5.825 - 5.835 MHz 149,153,157,161
To Next Page
Loading...
