ASCOM I62 - Static IP Address (Manual) Settings; Network Settings; Ssid; Voice Power Save Mode

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
30
6.2.2 Static IP Address (Manual) Settings
1 Select Network > Network A (or B, C, D).
2 In the DHCP mode drop-down list, select “Disable (static mode)”. Additional
parameters will be displayed.
3 In the Phone IP address field, enter the unique IP address for the handset.
4 In the Subnet mask field, enter the subnet mask.
5 In the Default gateway field, enter the IP address for the default gateway.
DNS Server Settings
It is possible to configure which DNS server the handset shall use. If the primary DNS server
is available, it is always used. Otherwise, the secondary DNS server will be used.
Note: The DNS parameters are only visible if the DHCP mode is set to “Disable (static
mode)”, see 6.2.2 Static IP Address (Manual) Settings.
Primary DNS Server
1 Select Network > Network A (B, C, or D).
2 In the Primary DNS field, enter the IP address to the primary DNS server.
Secondary DNS Server
1 Select Network > Network A (B, C, or D).
2 In the Secondary DNS field, enter the IP address to the secondary DNS server.
6.3 Network Settings
6.3.1 SSID
The SSID is the name of the network the handset associates to.
1 Select Network > Network A (B, C, or D).
2In the SSID field, enter system SSID.
Note that the SSID is case-sensitive.
6.3.2 Voice Power Save Mode
The voice power save mode is used during calls. NONE is recommended to obtain optimal
voice quality. U-APSD uses less power but is more sensitive to network disturbances.
If supported by the infrastructure U-APSD is the preferred choice and multiple the talk time
more than 4 times compared to NONE mode.
1 Select Network > Network A (B, C, or D).
2In the Voice power save mode drop-down list, select one of following:
•NONE
•U-APSD