ASCOM I62 - Push-To-Talk (PTT) Group Call; Presence Management

TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
54
4 Select the service to be used:
•Phone Call
• Send a message to predefined number (prompt for the message text)
• Send data to message service centre (predefined data and/or prompt for the
data)
• Edit alarm data
•PTT
5In the Service user data field, enter the data to be sent/dialed when using the
service. Note: This field is not applicable for PTT.
6In the Service prefix for user data field, enter the prefix for the service user data (if
needed).
7In the Service index field, enter the corresponding index used for PTT. For example, if
PTT group 1 is configured (located under Push-To-Talk > 1), the service index must
be set to 1. Note: This field is only applicable for PTT.
If the PTT is not configured, continue, with 6.13 Push-To-Talk (PTT) Group Call.
Tip: It is also possible to configure soft keys to reach services quickly, see 6.5.11 Shortcuts
on page 40.
6.13 Push-To-Talk (PTT) Group Call
To be able to configure a PTT session, the following must be known:
• The group number to the PTT group (defined in the IMS2).
• The phone number to the conference bridge.
Tip: For more information about the PTT function, see also Function Description, Ascom
VoWiFi System, TD 92314GB or User Manual i62 VoWiFi Handset, TD 92599GB.
Note: If Music on Hold (MOH) is used in the system it can effect an ongoing PTT group call. If
someone in the group conference answers another incoming call, MOH will be played for the
whole group.
1 Select Push-To-Talk > X (where X represents 1-10).
2In the Session name field, enter a name to identify the PTT session.
3In the Group number field, enter the number to the PTT conference group.
4In the Display text field, enter a text to be shown in the display during the PTT
session.
5In the PTT session signal drop-down list, select the indication of the PTT session.
6In the Conference number field, enter the phone number to the conference bridge.
7In the Answer mode drop-down list, select the answer mode for the PTT session.
8In the Speaker mode drop-down list, select the speaker mode for the PTT session.
9A Service must be configured to access the PTT session from the handset. If not
configured, continue with 6.12.2 Services.
6.14 Presence Management
To be able to configure presence management, the following must be known:
• The IP address to the Presence Management system.
• The user name and password used in the Presence Management system for each
handset.