Chapter 3: Introduction
This document provides information you need to configure system monitoring for the Ethernet Routing
Switch 3500 Series.
ACLI command modes
Avaya command line interface (ACLI) provides the following configuration modes:
• User EXEC
• Privileged EXEC
• Global Configuration
• Interface Configuration Mode
Mode access is determined by access permission levels and password protection.
If no password is set, you can enter ACLI in User EXEC mode and use the enable command
to move to the next level (Privileged EXEC mode). However, if you have read-only access, you
cannot progress beyond User EXEC mode, the default mode. If you have read-write access
you can progress from the default mode through all of the available modes.
With sufficient permission, you can use the rules in the following table to move between the
command modes.
Command mode and
sample prompt
Entrance commands Exit commands
User EXEC
3526T>
No entrance command,
default mode.
Type exitor logout
Privileged EXEC
3526T#
From User EXEC mode, type:
enable
Type exit or logout
Global Configuration
3526T(config)#
From Privileged EXEC mode,
type: configure
To return to Privileged EXEC
mode, type: end or exit
To exit ACLI completely, type:
logout
Interface Configuration
3526T(config-
if)#
From Global Configuration
mode:
To configure a port, type:
interface
To return to Global
Configuration mode, type:
exit
Configuration — System Monitoring March 2013 17
To Next Page
Loading...
