Variable definitions
The following table describes the parameters for the default logging remote
command.
Variable Value
address Restores the primary remote system log
server IP address to the factory default
DEFAULT: 0.0.0.0
facility Restores factory default remote logging
facility
level Restores the remote server logging level to
the factory default
DEFAULT: none
secondary-address Restores the secondary remote system log
server IP address to the factory default
DEFAULT: 0.0.0.0
Restoring Remote System Logging using ACLI
Restore to factory default the logging of system messages on a remote server.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
default logging remote [address] [secondary-address] [level]
[facility]
Software exception log using ACLI
This section describes ACLI commands that you use to display and clear software exception
logs.
Network monitoring configuration using ACLI
34 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
