Avaya 3500 series - Disabling Remote System Logging Using ACLI

Variable Value
critical Displays critical log messages
informational Displays informational log messages
serious Displays serious log messages
sort-reverse Displays informational log messages in
reverse chronological order (beginning with
most recent)
unit<1–8> Specifies log messages for a specific switch
Disabling Remote System Logging using ACLI
Disable the logging of system messages on a remote server.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
no logging remote [address] [secondary-address] [enable]
[level] [facility]
Variable definitions
The following table describes the parameters for the no logging remote command.
Variable
Value
address Clears the primary remote system log server
IP address
enable Disables system logging on the remote
server
level Clears the remote server logging level
secondary-address Clears the secondary remote system log
server IP address
Facility Restores factory default remote logging
facility
System logs using ACLI
Configuration — System Monitoring March 2013 33