Clearing Log Messages using ACLI
Clear all log messages in DRAM.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
clear logging [non-volatile] [nv] [volatile]
Variable definitions
The following table describes the parameters for the clear logging command.
Variable Value
non-volatile Clears log messages from NVRAM.
nv Clears log messages from NVRAM and
DRAM.
volatile Clears log messages from DRAM.
Configuring Remote System Logging using ACLI
Manage the logging of system messages on a remote server.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
logging remote [address <A.B.C.D | WORD>] [secondary-address
<A.B.C.D | WORD>] [enable} {level <critical|informational |
none | serious>] [facility <daemon| local0 | local1 | local2
| local3 | local4 | local5 | local6 | local7>]
Network monitoring configuration using ACLI
30 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
