Port Statistics using ACLI
This section contains information about how you can display the statistics for a port for both
received and transmitted traffic.
Displaying Port-Statistics using ACLI
Display port statistics.
Procedure
1. Log on to ACLI in Interface Configuration command mode.
2. At the command prompt, enter the following command:
show port-statistics [port <portlist>]
Example
The following figure provides a sample of show port-statistics command.
3524GT-PWR+#show port-statistics port 1
Received
Packets: 0
Multicasts: 0
Broadcasts: 0
Total Octets: 0
FCS Errors: 0
Undersized Packets: 0
Oversized Packets: 0
Filtered Packets: 0
Frame Errors: 0
Pause Frames: 0
Transmitted:
Packets: 0
Multicasts: 0
Broadcasts: 0
Total Octets: 0
Collisions: 0
Single Collisions: 0
Multiple Collisions: 0
Excessive Collisions: 0
Deferred Packets: 0
Late Collisions: 0
Pause Frames: 0
Packets 64 bytes: 0
65-127 bytes: 0
128-255 bytes: 0
256-511 bytes: 0
512-1023 bytes: 0
1024-1518 bytes: 0
Jumbo: 0
Port Statistics using ACLI
Configuration — System Monitoring March 2013 37
To Next Page
Loading...
