Avaya 3500 series - System Logs Using ACLI; Displaying the System Event Log Using ACLI

Variable definitions
The following table describes the parameters for the show memory-utilization
command.
Variable Value
<1–8> Specifies the number of a specific unit
System logs using ACLI
This section describes ACLI command that you use to configure and manage the system
logs.
Displaying The System Event Log using ACLI
Display the configuration and the current contents of the system event log.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
show logging
Variable definitions
The following table describes the parameters for the show logging command.
Variable
Value
config Specifies the configuration of event logging.
critical Displays critical log messages.
informational Displays informational log messages.
serious Displays serious log messages.
sort-reverse Displays informational log messages in
reverse chronological order (beginning with
most recent).
Network monitoring configuration using ACLI
28 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com