4. In the Status section, configure as required.
5. On the toolbar, click Apply.
Variable definitions
The following table describes the variables associated with displaying network topology
information.
Name Description
IpAddr Indicates the IP address of the device.
Status Specifies whether Avaya topology is on
(topOn) or off (topOff) for the device.
DEFAULT: topOn
NmmLstChg Indicates the value of sysUpTime the last
time an entry in the network management
MIB (NMM) topology table was added,
deleted, or modified. If the table has not
changed since the last cold or warm start of
the agent.
NmmMaxNum Indicates the maximum number of entries in
the NMM topology table.
NmmCurNum Indicates the current number of entries in the
NMM topology table.
Displaying the topology table using EDM
Use this procedure to display the topology table.
Procedure
1. From the navigation tree, double-click Edit.
2. In the Edit tree, click Diagnostics.
3. In the Diagnostics work area, click the Topology tab.
4. In the Topology section, click the Topology Table tab.
Network monitoring configuration using Enterprise Device Manager
50 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
