Variable definitions
The following table describes the variables associated with displaying the topology table.
Variable Value
Slot Indicates the slot number in the chassis in
which the topology message was received.
Port Indicates the port on which the topology
message was received.
IpAddr Indicates the IP address of the sender of the
topology message.
SegId Indicates the segment identifier of the
segment from which the remote agent sent
the topology message. This value is
extracted from the message.
MacAddr Indicates the MAC address of the sender of
the topology message.
ChassisType Indicates the chassis type of the device that
sent the topology message.
BkplType Indicates the backplane type of the device
that sent the topology message.
LocalSeg Indicates if the sender of the topology
message is on the same Ethernet segment
as the reporting agent.
CurState Indicates the current state of the sender of
the topology message. The choices are:
• topChanged — Topology information has
recently changed.
• heartbeat — Topology information is
unchanged.
• new — The sending agent is in a new
state.
Port Mirroring using EDM
This section provides procedures to display and configure the Port Mirroring feature using
EDM.
Port Mirroring using EDM
Configuration — System Monitoring March 2013 51
To Next Page
Loading...
