Displaying System Logging Information using ACLI
Configures information for system logging.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
show logging [config] [critical] [informational] [serious]
[sort-reverse] [unit <1–8>
Example
The following figure provides a sample of show logging command.
3524GT-PWR+#show logging
Type Time Idx Src Message
---- ----------------------------- ---- --- -------
S 00:00:00:00 1 NVR Switch IP changed
S 00:00:00:00 2 NVR Gateway IP changed
S 00:00:00:00 3 NVR Download - AGENT image
v5.0. 0.38 programmed successfully
S 00:00:00:00 4 NVR Download - AGENT image
v5.0. 0.40 programmed successfully
S 00:00:00:00 5 NVR Download - AGENT image
v5.0. 0.41 programmed successfully
S 00:00:00:00 6 NVR #1 Reset initiated through
telnet by IP address:
192.168.20 1.149, access mode: no security
S 00:00:00:00 7 NVR Download - AGENT image
v5.0. 0.41 programmed successfully
S 00:00:00:00 8 NVR Download - AGENT image
v5.0. 0.41 programmed successfully
I 00:00:00:17 9 Web server starts service on
port 80.
I 00:00:01:56 10 Warm Start Trap
I 00:00:01:56 11 Trap:
lldpXMedTopologyChangeDetected, Subtype = 4
Class = 4
I 00:00:01:56 12 Trap:lldpRemTableChange Inserts =
----More (q=Quit, space/return=Continue)----
Variable definitions
The following table describes the parameters for the show logging command.
Variable
Value
config Displays local and remote system logging
configuration status
Network monitoring configuration using ACLI
32 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
