Variable definitions
The following table describes the parameters for the logging remote command.
Variable Value
address <A.B.C.D | WORD> Specifies the primary remote system log
server IP address.
• A.B.C.D is the IPv4 address of the remote
server
• WORD is the remote host IPv6 address.
The value is a character string with a
maximum of 45 characters.
enable Enables system message logging on the
remote server. You must configure either the
primary or secondary remote server IP
address before you can enable remote
logging.
facility <daemon| local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7>
Specifies remote logging facility.
level<critical|informational|none|serious> Specifies the level of system messages to
send to the remote system log server:
• critical —only events classified as critical
are sent to the remote system log server
• serious —only events classified as serious
are sent to the remote system log server
• informational —only events classified as
informational are sent to the remote log
server
• none —no system log messages are sent
to the remote system log server
secondary-address<A.B.C.D|<WORD> Specifies the secondary remote system log
server IP address:
• A.B.C.D. is the IPv4 address of the remote
server
• WORD is the remote host IPv6 address.
The value is a character string with a
maximum of 45 characters
System logs using ACLI
Configuration — System Monitoring March 2013 31
To Next Page
Loading...
