Variable definitions
The following table describes the variables associated with configuring IPv4 remote access.
Variable Value
Allowed Source IP Address Specifies the source IPv4 address to permit
remote access to the switch.
Allowed Source Mask Specifies subnet mask associated with the
source IPv4 address to permit remote
access to the switch.
Configuring the IPv6 remote access list using EDM
Use this procedure to configure a list of IPv6 source addresses for which to permit remote
access to a switch.
Procedure
1. From the navigation tree, double-click Administration.
2. In the Administration tree, click Remote Access.
3. In the Remote Access work area, click the Allowed List (IPv6) tab.
4. In the Allowed List (IPv6) section, configure as required.
5. On the toolbar, click Apply.
Variable definitions
The following table describes the variables associated with configuring IPv6 remote access.
Variable
Value
Allowed Source IPv6 Address Specifies the source IPv6 address to permit
remote access to the switch.
Allowed Prefix Length Specifies prefix length for the source IPv6
address to permit remote access to the
switch.
RANGE:
0–128.
Configuring the IPv6 remote access list using EDM
Configuration — System Monitoring March 2013 83
To Next Page
Loading...
