Displaying last generated software exception log using ACLI
Display the last generated software exception log for debugging purposes.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
show system last-exception
Note:
This command produces output that is a series of hex values that can only be
decoded by a developer. Use the show logging command to produce
readable exception log information.
Example
The following figure provides a sample of the exception log as displayed in NVRAM using the
show logging command.
Type Time Idx Src Message
------------------------------------
C 00:00:00:06 7 Sw Exception: Task tFault, Type Data Access, PC 0x00c792c4,
SP 0x0675af70
Clearing last generated software exception log using ACLI
Erase the last generated software exception log after viewing.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
clear system last—exception
Port Mirroring using ACLI
This section describes the ACLI commands that you use to configure and display port
mirroring.
Port Mirroring using ACLI
Configuration — System Monitoring March 2013 35
To Next Page
Loading...
