Dropped on No Resources: 0
3524GT-PWR+#
Variable definitions
The following table describes the parameters for the show port-statistics command.
Variable Value
port<portlist> Specifies the port numbers for which to
display statistics.
Important:
If you omit this parameter, the system
uses the port number you specified when
selecting the interface.
Clearing Statistical Information using ACLI
Clear all statistical information for the specified port and set all counters to zero (0).
Procedure
1. Log on to ACLI in Interface Configuration command mode.
2. At the command prompt, enter the following command:
clear-stats [port <portlist>]
Variable definitions
The following table describes the parameters for the clear-stats command.
Variable
Value
port<portlist> Specifies the port number for which to
display statistics
Important:
If you omit this parameter, the system
uses the port number you specified when
selecting the interface.
Network monitoring configuration using ACLI
38 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
