Chapter 5: Network monitoring
configuration using ACLI
Displaying CPU Utilization using ACLI
Display CPU utilization for all units or a specific unit.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
show cpu-utilization <1–8>
Variable definitions
The following table describes the parameters for the show cpu-utilization command.
Variable
Value
<1–8> Specifies the number of a specific unit.
Displaying Memory Utilization using ACLI
Display memory utilization for all units or a specific unit.
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
show memory-utilization <1–8>
Configuration — System Monitoring March 2013 27
To Next Page
Loading...
