Configuring RMON Events Settings using ACLI
Configure RMON event log and trap settings.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
[no] rmon event <1–65535> [log] [trap] [description <LINE>]
[owner <LINE>]
Variable definitions
The following table describes the parameters for the rmon event command.
Variable
Value
[no] Deletes RMON event table entries. When the
variable <1–65535> is omitted, all entries in
the table are cleared.
<1–65535> Specifies the unique index for the event entry
[log] Records events in the log table
[trap] Generates SNMP trap messages for events
[description]<LINE> Specifies a textual description for the event
[owner]<LINE> Specifies the owner string to identify the
event entry
Configuring RMON History Settings using ACLI
Configure RMON history settings
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
RMON using ACLI
76 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com
To Next Page
Loading...
