Avaya 3500 series - Configuring Leds to Blink on the Display Panel Using ACLI

Configuring LEDs to blink on the Display Panel using ACLI
Set the LEDs on the display panel to blink to identify a particular unit
Procedure
1. Log on to ACLI in Privileged EXEC command mode.
2. At the command prompt, enter the following command:
blink-leds [off | time <1–10> | unit <1–8> ]
Example
The following figure provides a sample of the blink-leds command.
Variable definitions
The following table describes the parameters for the blink-leds command.
Variable
Value
[off | time<1–10> Specifies whether the LEDs blink or not [off].
If the LEDs blink, this parameter is set to blink
from 1 to 10 times
unit<1–8> Specifies which unit [1 to 8] will blink
Configuring LEDs to blink on the Display Panel using ACLI
Configuration — System Monitoring March 2013 39