Variable Value
delta Specifies delta values (change in the value
of the MIB object between samples is
compared with thresholds)
rising-threshold<-2147483648–2147483647
> [ <1–65535>]
Specifies the first integer value is the rising
threshold value. The optional second integer
specifies the event entry to be triggered
when the rising threshold is crossed. If
omitted, or if an invalid event entry is
referenced, no event is triggered. Unique
index for the alarm entry
falling-threshold<-2147483648–
2147483647 > [ <1–65535>]
Specifies the first integer value is the falling
threshold value. The optional second integer
specifies the event entry to be triggered
when the falling threshold is crossed. If
omitted, or if an invalid event entry is
referenced, no event is triggered. Unique
index for the alarm entry.
[owner <LINE>] Specifies the owner string to identify the
alarm entry
Deleting RMON Alarms using ACLI
To delete RMON alarm table entries.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
no rmon alarm [<1–65535>]
Variable definitions
The following table describes the parameters for the no rmon alarm command.
Variable
Value
<1–65535> Specifies the unique identifier of the alarm.
When the variable is omitted, all entries in the
table are cleared
Deleting RMON Alarms using ACLI
Configuration — System Monitoring March 2013 75
To Next Page
Loading...
