Avaya 3500 series - Configuring Port-Mirroring Using ACLI; Disabling Port-Mirroring Using ACLI

Configuring Port-Mirroring using ACLI
Configure port mirroring.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
port-mirroring mode {disable|Xrx|Xtx|XrxOrXtx} monitor-port
<portlist> mirror-port-X <portlist>
Variable definitions
The following table describes the parameters for the port-mirroring mode command.
Variable Value
disable Disables port-mirroring
Xrx Mirrors packets received on port X
Xtx Mirrors packets transmitted on port X
XrxOrXtx Mirrors packets received or transmitted on
port X
<portlist> Specifies the port to be configured
Disabling Port-Mirroring using ACLI
Disable port mirroring.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
no port-mirroring
Network monitoring configuration using ACLI
36 Configuration — System Monitoring March 2013
Comments? infodev@avaya.com