10. In the Save Targets box, select the types of messages you want the system to
report to the remote system log server or servers (if you are using Dual Syslog
Servers).
11. In the Facility box, specify the remote logging facility.
12. On the toolbar, click Apply.
Remote System Log tab field descriptions
The following table describes the fields on the Remote System Log tab.
Name Description
RemoteSyslogAddressType Specifies the type of IP address for the
remote system log server.
RemoteSyslogAddress Specifies the IP address for the remote
system log server to send system log
messages to.
SecondarySyslogAddressType Specifies the type of IP address for the
secondary remote system log server.
SecondarySyslogAddress Specifies the IP address for the secondary
remote system log server to send system log
messages to.
Enabled Specifies whether or not remote logging is
enabled.
Save Targets Determines the type of log messages that
are saved in the log message buffer
facilities.
Messages are classified based on their type
as follows:
• critical: only messages classified as
critical are sent to the remote system log
server
• critical/serious: only messages classified
as critical and serious are sent to the
remote system log server.
• critical/serious/inform: only messages
classified as critical, serious, and
informational are sent to the remote
system log server.
• none: no system log messages are sent to
the remote system log server.
Configuring remote system logging using EDM
Configuration — System Monitoring March 2013 45
To Next Page
Loading...
