DDT; Reviewed:
SPOC 10/18/2017
Solution & Interoperability Test Lab Application Notes
©2017 Avaya Inc. All Rights Reserved.
6.5. Processor Ethernet Configuration
The display ip-interface procr command can be used to verify the Processor Ethernet (procr)
parameters defined during installation.
Verify that Enable Interface?, Allow H.323 Endpoints?, and Allow H248 Gateways?
fields are set to y.
In the reference configuration the procr is assigned to Network Region: 1.
The default values are used for the remaining parameters.
6.6. IP Codec Sets
6.6.1 Codecs for IP Network Region 1 (calls within the CPE)
Step 1 - Enter the change ip-codec-set x command, where x is the number of an IP codec set used
for internal calls (e.g., 1). On Page 1 of the ip-codec-set form, ensure that G.711MU, and
G.729A are included in the codec list.
change ip-codec-set 1 Page 1 of 2
IP Codec Set
Codec Set: 1
Audio Silence Frames Packet
Codec Suppression Per Pkt Size(ms)
1: G.722-64K 2 20
2: G.711MU n 2 20
3: G.729A n 2 20
Media Encryption Encrypted SRTCP: enforce-unenc-srtcp
1: 1-srtp-aescm128-hmac80
2: none
change ip-interface procr Page 1 of 2
IP INTERFACES
Type: PROCR
Target socket load: 4800
Enable Interface? y Allow H.323 Endpoints? y
Allow H.248 Gateways? y
Network Region: 1 Gatekeeper Priority: 5
IPV4 PARAMETERS
Node Name: procr IP Address: 10.64.91.65
Subnet Mask: /24
To Next Page
Loading...
