Avaya S8500 - Page 62

Upgrading and administering the existing hardware
62 Migrating to the Avaya S8700 or S8710 Media Server
June 2004
16 Assign the Switch and Cabinet ID to the TN2312BP Internet Protocol Server Interface (IPSI-2)
just inserted. See Assigning IP addresses to the IPSI circuit packs
on page 107.
17 Type set tone cabinet carrier and press Enter to force a tone-clock interchange.
18 Type status port-network number where number is the number of the port network and press
Enter to verify that the tone-clock moved to the other carrier. Verify that the YELLOW LED on
the IPSI circuit pack is flashing.
19 Remove the TN2182 Tone Clock circuit pack from the new standby carrier (B) and place in an
antistatic carrier.
20 Insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack part way into the
TONE-CLOCK slot on the standby carrier (B).
21 With the red line on the bottom (pin 1), attach one end of the long ribbon cable to the connector on
the component side of the circuit pack.
22 Push the tabs on the ends of the connector inward to lock the connector in place. See Figure 4,
Ribbon Cable Connector, on page 59.
23 Thread the ribbon through the slot on the front panel.
24 Attach the other end of the long ribbon cable to the bottom connector on the component side of
the TN775D Maintenance (EPN) circuit pack (red line on the bottom). See Figure 6, High/Critical
Reliability Ribbon Cable Connection, on page 63.
25 Fully insert the TN2312BP Internet Protocol Server Interface (IPSI-2) circuit pack.
26 Program the TN2312BP Internet Protocol Server Interface (IPSI-2) just inserted. See Assigning
IP addresses to the IPSI circuit packs on page 107.
27 Fully insert the TN775D Maintenance (EPN) circuit pack after both IPSIs have been
programmed.