Connecting to the IP server interfaces
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway 185
December 2003
4 Type arp -d 192.11.13.6 and press Enter to clear the ARP cache in the laptop. This command
responds with one of the following:
• The command line prompt when the cache has been cleared.
• The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
5 Type telnet 192.11.13.6 and press Enter to open the Telnet window and connect to the IPSI
Prompt = [IPSI]:
NOTE:
While connected to the IPSI, type help or ? to obtain online help. Most commands have
two or three letter abbreviations.
6 Type ipsilogin and press Enter. (abbreviated command = il)
NOTE:
The craft login used on the IPSI has a different password than the craft login used on the
media servers.
7 Log in as craft.
Prompt = [IPADMIN]:
8 Type set control interface ipaddr netmask and press Enter, where ipaddr is the customer-
provided IP address and
netmask is the customer provided subnet mask.
9 Press Enter to effect the changes.
To Next Page
Loading...
