Avaya S8700 - Page 186

Connecting to the IP server interfaces
186 Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
10 Type show control interface and press Enter.
The IP address, subnet mask, and default gateway information will be displayed.
Verify that the proper information was entered.
11 If required, type set control gateway gateway and press Enter, where gateway is the customer-
provided IP address for their gateway.
12 Press Enter to effect the changes.
13 If required, use the set vlan priority, set vlan tag, set vlan id, and set diffserv commands to
enter VLAN and diffserv parameters for the IPSI. Use Help to obtain syntax guidelines for these
commands.
14 Type reset and press Enter
Answer Y to the warning.
NOTE:
Resetting the IPSI terminates the administration session. If further administration is
required, start a new telnet session to the IPSI.
15 Type quit to logoff the IPSI.
NOTE:
Control network settings (IP address, subnet mask, and gateway) become effective when
you exit the IPADMIN session.
16 Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See Figure 74,
LED display showing that the IPSI has a static IP address, on page 186)
Figure 74: LED display showing that the IPSI has a static IP address
17 Disconnect the laptop from the faceplate.
NOTE:
Always use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the
laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to
hang and does not connect to the next IPSI.
18 Repeat for each IPSI circuit pack.
CLK
S
E
R
V
fpdlled1 LJK 022502