204
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Connecting to the IPSIs
May 2003
Connecting directly to the IPSI
1 Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2 From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3 Type command and press Enter to open a MSDOS Command Line window.
4 Type arp -d 192.11.13.6 and press Enter to clear the ARP cache in the laptop. This
command will respond with one of the following:
• The command line prompt when the cache has been cleared.
• The phrase: The specified entry was not found. This is returned when the
specified IP address does not currently contain an entry in the ARP cache.
5 Type telnet 192.11.13.6 and press Enter to open the Telnet window and connect to the
IPSI.
Prompt = [IPSI]:
NOTE:
While connected to the IPSI type help or ? to obtain online help. Most commands have
two or three letter abbreviations.
6 Type ipsilogin and press Enter. (abbreviated command = il)
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
3 NIC adapter cable (if necessary)
4 CAT5 crossover cable to IPSI
cadlipsi KLC 031502
1
2
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
3
4
To Next Page
Loading...
