Appendix D: MV3000e Drive Selection Charts T1689 Technical Manual Rev 07
MV3000 Air Cooled DELTA
Page 186
575 – 690 V a.c. Units: 150% Overload
Amps
Power
Losses
(kW)
Amps
Power
Losses
(kW)
Amps
Power
Losses
(kW)
Table 13–4. – MVD300 Ratings in 1.5 Overload
Ratings are based on:
• Rectifier fed (Diode Front End) drive with a d.c. link voltage = 1.35xVac,
• No sharing reactor in DELTA air stream (e.g. 31V5500/10 not fitted)
• Typical device characteristics
• 50 000 hours continuous use for d.c. capacitor bank
• Overloads are for 60s every 10minutes. The current must be reduced between overloads so that
the rms current does not exceed the rated current shown.
• A.C. output current shown in Amps (rms)
• Ratings assume the use of the High Performance Cooling System.
NOTE: Full kit lists are available from GE Power Conversion.