Avocent MERGEPOINT SP MANAGER - Page 141

Parameter
Level 1
Parameter
Level 2
What It Configures (Syntax)
pxe mapping
Add a MAC address.
Synopsis: add pxe mapping <MAC_ address>
Example: add pxe mapping 00602e01d9a6
NOTE: No colon (:) is needed in the MAC address.
See the set command for the following parameters: pxe mapping on page 142 and pxe
setting on page 143.
snmpd user
Add a user and fills in the subtree with default values and randomly generated
passwords.
Synopsis: add snmpd user <user_name>
Example: add snmpd user user1
group
Add a group.
Synopsis: add snmpd group <group_name>
Example: add snmpd group g1
view
Add a view.
Synopsis: add snmpd view <view_name>
Example: add snmpd view ies
access
Add an access type.
Synopsis: add snmpd access <noauth|auth|authpriv>
Example: add snmpd access auth
com2sec
Add a com2sec type.
Synopsis: add snmpd com2sec <type>
Example: add snmpd com2sec mp1
proxy
Add an snmpd proxy.
Synopsis: add snmpd proxy <proxy_name>
Example: add snmpd proxy 0
Chapter 7: Using the CLI Utility 129