Parameter
Level 1
Parameter
Level 2
What It Configures (Syntax)
server-
groups
Add the name of a server group.
Synopsis: add spmanager server-groups <groups_name>
Example: add spmanager server-groups MergePoint2.
NOTE: To add a device into a server group, see the set command for the following
parameter spmanager server on page 145.
global role
Add an appliance user role.
Synopsis: add spmanager global role <role_name>
Example: add spmanager global role role_aa
NOTE: To set the privilege of the global role, see the set command for the following
parameter: spmanager global role on page 146.
cd
The cd command sets a parameter prefix for subsequent commands. The prompt then changes to
indicate the prefix. Entered by itself, cd returns to the top level.
Synopsis
cd [parameter(s)]
Examples
cli> cd network
network> get hostname
dingo
network> set hostname kookaburra
OK
network> cd interface eth0
network interface eth0> set <tab><tab>
address alias broadcast gateway method mtu netmask
network interface eth0> set address 192.168.160.10 netmask 255.255.255.0
OK
network interface eth0> cd ..
network interface> cd eth1
network interface eth1> set address 192.168.50.10
OK
Chapter 7: Using the CLI Utility 131
To Next Page
Loading...
Need help?
General
