AVPro Edge MXNet 1G - Page 25

Page 25 of 78
MXNET 1G USER MANUAL
•
MGMT LED steadily flashes green to indicate a stable link is present on
the MGMT port
8
RST
•
Use a paperclip or pen to press in and hold for 7 seconds to reset the
network switch to factory default settings
9
CONSOLE PORT
•
8-pin RJ-45 female connector port
• Used for accessing the MXNet CLI (Command Line Interface)
10
100~240V AC,
50~60Hz 3A
POWER SUPPLY
•
Main AC power supply for the network switch
11
GROUND SCREW
• Connect with a grounding cable to the conducting parts