Axion 40 Series - 2.2.1. MAIN POWER CABLE

© AXION TECHNOLOGIES LTD. INSTALLATION
Figure 42: Electrical Interconnection in Section 6.1 shows a detailed view of the system
components interconnection. It shows the types of connectors and cables used including a
definition for each of the signals of these different cables.
The following paragraphs describe in detail each of the different cables used to interconnect
system components.
2.2.1. MAIN POWER CABLE
The main power cable is made up of three (3) or four (4) wires:
● BATT+
● GND
● IGN
● ACC (optional)
User Manual (Revision A) Document No.: 3042145 Page 8
Figure 1: System Components Interconnection and Location
SIGNAL CÉDEZ
YIELD SIGNAL
UNITÉ DE CONTROLE
CONTROL UNIT
AFFICHEUR
ARRIÈRE
REAR SIGN
AFFICHEUR
NUMÉRO DE POSTE
KEY NUMBER SIGN
SIGNAL DE
DÉTRESSE
EMERGENCY
SIGNAL
AFFICHEUR
CÔTÉ CHAUSSÉE
ROUTE SIDE SIGN
AFFICHEUR
AVANT
FRONT SIGN
AFFICHEUR
CÔTÉ TROTTOIR
CURB SIDE SIGN