R5905754 /13 DPxK-32B130
9.1 Switching ON the DPxK-32B series projector
How to switch on
1. Make sure that the DPxK-32B projector is installed upon a stable pedestal. See chapter “Positioning the
DPxK-32B at port window”, page 24.
2. Make sure that the exhaust system is properly installed. See chapter “Installation of the exhaust system”, page
26.
3. Make sure that the right lens is installed for your application. See chapter “Lens selection”, page 60.
4. Make sure that the lamp and lamp house are correctly installed. See chapter “Lamp & Lamp House”, page 35.
5. Make sure the projector is correctly connected to the power net. See chapter “Connecting the DPxK-32B with
the power net”, page 30.
6. Check if a video source is connected with the projector. See chapter “Input & communication”, page 77.
7. Check if the communicator touch panel is installed. See chapter “Communicator Touch Panel”, page 123..
8. Press the power switch to switch ON the projector. As a result the projector starts up in standby. So, the lamp
is OFF and the dowser closed. No internal pattern is selected. The communicator touch panel starts its
initialization procedure.
• When '0' is visible, the projector is switched OFF.
• When '1' is visible, the projector is switched ON.
9. Press the STANDBY button on the local keypad or use the Communicator Touch Panel to activate the lamp.
10. Press the DOWSER button on the local keypad or use the Communicator Touch Panel to open the dowser. As
a result the applied source will be displayed.
CAUTION: See user's guide of the Communicator Touch Panel to operate and control the DPxK-
32B.
When for any reason a restart of the projector is required, the content server should be restarted
also.
9.2 Switching OFF the DPxK-32B
How to switch OFF the DPxK-32B?
1. Press the standby button on the local keypad or use the Communicator Touch Panel to switch the projector
from operation to standby. As a result the lamp turns off but the fans remain turning to cool down the projector.
2. Let the projector cool down at least 5 minutes or until the speed of the fans decreases.
3. Switch OFF the projector with the power switch.
Starting up
To Next Page
Loading...
Need help?
General
