Barco DP2K-12C

6. Lamps and lamp houses
Image 6-28
Light mode selection
6. Adjust the X-axis (ref X image 6-29), the Y -axis (ref Y image 6-29) and the Z -axis (ref Z image 6-29) for ma ximum current light
output (Footlam bert M easured). Car efully turn the thumbscrew for maxim um light output. Once over the m aximum , turn slightly
in oppos ite direction to reach the maximum light output again. Do this fo r eac h dire ction and repeat this adjustment cycle twice.
Z
X
Y
Image 6-29
Lamp adjustment
7. If lock nuts are available, these nuts can be locked again.
8. Switch off the projector.
9. Reinstall the cover of the lamp compartment.
112 R5905043 DP2K-12C/11CX 19/02/2018