Barco DP2K-12C - Page 239

12. Card Cage
1
2
3
4
5
6
9
10
11
8
7
Image 12-43
Backplane fixation screws
8. Pull the signal backplane a little bit forward Pivot the left side as far as possible and slide out the board.
Image 12-44
Signal backplane removal
9. Remove the p rojector ID card.
Push the c ard holder a few millimeters to the left until the lock opens.
Turn it over and slide out the projector ID card.
R5905043 DP2K-12C/11CX 19/02/2018
235