Baumer EA Series - Page 5

Baumer_EAx_EtherNetIP_EN_MNL 5/81 www.baumer.com
02.20
Disclaimer of liability
The present manual was compiled with utmost care, errors and omissions reserved. For this reason
Baumer rejects any liability for the information compiled in the present manual.
Baumer nor the author will accept any liability for direct or indirect damages resulting from the use of the
present information.
At any time we should be pleased receiving your comments and proposals for further improvement of the
present manual.
Created by:
Baumer IVO GmbH & Co. KG
Villingen-Schwenningen, Germany
Registered trademarks
Studio5000
®
and LogixDesigner
®
are registered trademarks of Allen-Bradley
®
.
Names mentioned in the present manual and other names that may be registered trademarks are not
marked correspondingly. Having omitted the respective marking does not necessarily imply that the names
are not registered trademarks or that there are no existing patents and protected patented designs.
Change history
This document is subject to changes. The latest version is available at www.baumer.com.
Document
index
Date
Firmware
revision
Author
Changes
0001
09.18
1.003
div.
Initial version
(replaces all draft documents)
0002
02.20
1.004
div.
Important changes:
editorial changes and
revision of following chapters:
- 5.4.1 ("Configuring an encoder module")
- 5.7 ("Configuration data")
- 6.3 ("Diagnostic LEDs")
- 6.5 ("Speed")
- 7.6.8 to 7.6.11 (“gear factor”)
- 7.6.12 ("Important note for multiturn encoder
operation")
- 7.13 ("Position Sensor Object (0x23)")
- 7.13.4 (“Instance Attributes“)
- 7.13.5 ("Error codes (Position Sensor
Object)")
New chapters:
- 7.6.15 ("Parameterization behaviour")
- 9 ("Appendix A")