EasyManua.ls Logo

Beaver Contessa - Aqua-Hot Overview; Washer-Dryer Prepared

Beaver Contessa
266 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
APPLIANCES — 4
104
20 08 CONTESSA
Spin lter onto head until lter makes
contact then tighten ¾ of a turn.
Start Aqua-Hot and check fuel lter for
leaks.
NOTE:
It may be necessary to cycle the diesel
burner switch on and off a few times to
thoroughly purge the fuel system of air.
Aqua-Hot Overview
General Layout:
An understanding of the general layout of the
Aqua-Hot system will help in operating and
troubleshooting the system.
WASHER-DRYER PREPARED
The washer-dryer “prep” package includes the
following items:
1. Color coded water supply lines: red for
hot and blue for cold.
2. A 1½" waste water drain line with
threaded cap, P-Trap, and an automatic
vent cap. This will drain the waste
water into the grey water holding tank.
3. A 120 AC Volt receptacle located in the
compartment.
NOTE:
Sidewall dryer vents are not part of the
prep package. If a sidewall vent is to be
installed, properly seal vent to sidewall.
If a washer-dryer is to be installed at a later
date, follow all the manufacturer installation
instructions. Listed here are further instructions
which should be adhered to for safe and reliable
operation:
DO NOT connect the clothes dryer
exhaust duct to any other duct, vent or
chimney.
DO NOT terminate the exhaust duct
beneath the motorhome.
Use proper length fasteners when
attaching exhaust vent to exterior
sidewall. Stainless steel fasteners are
best suited for this as they will not rust.
RM03B0001C
040495c

Table of Contents