Marker Flashlamp: Pressing Marker
Flash lamp causes the taillights and all
marker lights to momentarily ash.
OFF: Cancels all wiper operations.
Wiper function is also cancelled when
the ignition is turned off.
HI-LO: Wipers activate on low
speed when the button is pressed.
If the button is pressed again, the
high wiper speed setting is activated.
Subsequently pressing the HI-LO
button will alternate wiper operation
between low and high speed mode.
Wiper Wash: Activates wash pump
relay when the button is pressed. If
no wiper function is selected, the low
wiper will activate for a period of
approximately three wiper cycles after
the switch is released. If any wiper
functions are selected, the wipers will
continue to run in the selected mode
after the wash button is released.
Wiper Variable: Operation of the
Wiper Variable button causes the low
speed wiper function to activate for
one wipe. If the button is pressed again
within approximately 30 seconds, the
low speed wiper function activates
and repeats at an interval determined
by the time between the last two
operations of the button. Additional
button operations will shorten the
cycle. Activating other wiper modes
cancels the variable mode.
Example: In light rain or misting conditions
press the button once to initially clear the
windshield. If the windshield requires a second
clearing, press the button again, setting the
timed interval between subsequent wipes
required by the current conditions. To extend the
wipe interval, press the intermittent button twice
more, or switch the wipers off and use the same
method to set the desired interval.
Tilt & Telescope
Tilt and telescope steering wheel control lever
is located on the steering column.
To Tilt the Steering Wheel: Pull the
lever up and tilt the steering wheel to the
desired level. Release the lever to lock
the steering wheel in the new position.
To Telescope the Steering Wheel:
Push and hold the lever down. Move the
steering wheel to the desired location.
Release the lever to lock the steering
wheel in the new position.
Turn indicator and headlight high/low dimmer
control is located on the steering column.
Push the lever forward to activate right
turn indicator circuits when the ignition
is on.
Pull the lever back to activate left turn
indicator circuits when the ignition is on.
Pull the lever up to select high/low beam
circuits when the headlights are on.
Hazard Flashers:
The asher button is located on the
steering column.
To turn on the four-way ashers, pull
out on the asher button. The turn signal
alarm will sound.
To turn off the ashers, push the button in.
CONSOLE
Transmission Shift Selector
NOTE:
Switch and component placement on
panels may vary.
To Next Page
Loading...