105
20 08 CONTESSA
APPLIANCES — 4
If the cabinet or closet in which a
washer-dryer is installed does not
have vented louvered doors, the
manufacturer’s installation instructions
may require installation of vented doors,
or vents to be installed in the doors for
sufcient circulation of air.
CAUTION:
It is highly recommended to hook
the motorhome to shore services
when using the washing machine due
to limited fresh water supply and
limited grey tank capacity. The washer
may drain into the black tank on some
floor plans.
WASHER-DRYER (Optional)
The automatic
washer-dryer is
front loading with
an extra large
door opening for
easier access.
Several wash and
dry programs are
available along
with variable
water temperature
settings.
Washer-dryer operates on 120 Volt AC
from shore power or generator.
Washer-dryer uses approximately 12 to
20 gallons of water per wash cycle.
INFORMATION:
Refer to the washer-dryer manufacturer’s
manual in the owner’s information file for
detailed operating instructions.
WARNING:
Open a window or vent while operating
the dryer. The washer-dryer can
create negative air pressure inside the
motorhome that can accumulate Carbon
Monoxide or propane while operating
fuel-burning appliances.
CAUTION:
DO NOT use the washer-dryer while
traveling. Suspension movement,
combined with the weight of the drum
while in the wash cycle, can damage the
internal components of the washer-dryer.
Test Procedure
Before using the washer for the rst time,
after winter storage or a long period of non-use,
conduct a simple test procedure to verify that
all the hardware and electronic components are
functioning. Wipe the interior and exterior of the
washer-dryer with a damp cloth to remove dust
that has accumulated.
NOTE:
Perform this test before putting the
washer-dryer in use for the first time
or after the winter months. This will
clear the water lines and drum of
winterization antifreeze.
Test Procedure Requirements:
Ensure water lines are secure and water
valves are open.
Hook to city water or turn on the water
pump.
Hook to shore power or start the
generator.
To Conduct the Test Procedure:
1. Set selector knob to Reset.
2. Set Dry Timer knob to 30 minutes.
Push the ON/OFF button to ON. Wait
ve seconds. The Auto Dry light
should be on and the Status light
ashes fast, then slow.
3. Set the selector knob to a wash cycle.
Set Wash Temp knob to Warm. Water
should ow into washer and the drum
should rotate both directions.
4. Set selector knob to Reset. Wait ve
seconds.
031017c
031017c
To Next Page
Loading...