Beaver Contessa - Cooling Unit Fans; Doors; Interior Light; Storage Procedures

91
20 08 CONTESSA
APPLIANCES — 4
Cooling Unit Fans
The cooling unit is equipped with a pair of
cooling fans that pass air across the cooling unit.
These fans start automatically and are audible
when in operation.
Doors
The refrigerator doors use a positive latch
that secures the door with a “click” to prevent
the door from opening during travel. The doors
use a heating element located in the apper
on the left door. The heating element activates
when operating the refrigerator in any mode
to help prevent moisture accumulation in high
humidity conditions.
In storage, a completely sealed refrigerator is
a perfect environment for mold and bacteria to
grow. When storing the motorhome, reduce odor
from mold and bacteria in the refrigerator by
using the door storage feature to lock the doors
partially open.
To use the storage feature, open doors enough
to slide tab into the cut-out of the strike plate.
Storage Procedures
Storage Feature:
Turn the refrigerator OFF and remove
all items. Leave the drip tray under the
cooling ns.
Shorten defrost time by using trays of
warm water. DO NOT use a heating
gun, hair dryer or sharp objects to
remove frost as these can damage the
interior or cooling unit.
Wash the interior using mild spray
cleaners or a solution of liquid dish
detergent and warm water. DO NOT use
scouring pads or abrasive cleaners that
can damage the interior nish.
Rinse with a solution of baking soda and
water. Dry with a clean cloth.
Lock the doors open.
CAUTION:
When defrosting, do not use a hot air
blower. Permanent damage could result
to plastic parts. DO NOT use a knife,
ice pick or any other sharp instrument
to remove ice from the freezer as they
can puncture the system.





Interior Light
The interior light is located at the top of the
fresh food compartment. When the door is open
the light will illuminate.
Bulb Replacement:
1. Remove the light cover by pulling it
toward the front of the refrigerator.
2. Remove the light bulb from the holder.
3. Install a GE#214-2 replacement bulb
and replace the cover.
030965c
031116