EasyManua.ls Logo

Beaver Contessa - Faucets; Water Filter

Beaver Contessa
266 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
133
20 08 CONTESSA
WATER SYSTEMS — 6
Water pump will not shut-off or continues
to run when the faucet is closed:
Check to see if the fresh water/tank ll
valve is completely closed.
Check the output (pressure) side
plumbing for leaks and inspect for a
leaky toilet or valves.
Look for a loose drive assembly or pump
head screws.
Water pump is noisy or rough in operation:
Check for plumbing that may have
vibrated loose.
Does the mounting surface multiply
noise (exible)?
Check for mounting feet that are loose or
compressed too tight.
Look for loose pump head to motor
screws.
Water pump is rapid cycling:
Look for restrictive water ow in the
faucets or shower heads.
FAUCETS
The kitchen faucet head has a exible hose
allowing the faucet head to be removed from
the base. O-rings seal the faucet head to the
base preventing water from dripping into the
cabinet. Push the button to select either stream
or spray. A liquid
soap dispenser is also
provided in the bath
and vanity for hand
washing.
To clean faucet screens:
Unscrew kitchen - screen retainer from
faucet head.
Lavatory/vanity - remove threaded collar
from faucet outlet.
Clean screen using a small, soft brush,
and a de-liming solution if necessary.
Install screen and check water ow.
WATER FILTER
A whole-house water lter is located behind
the water service center. Change the water
lter after 1,000 gallons of use, or sooner if
water ow is noticeably reduced.
Filter Replacement:
Turn off the water supply (turn off
water pump or disconnect from shore
services).
Open the kitchen faucet to relieve water
pressure.
Use the provided wrench
to loosen the lter
housing.
Finish unscrewing the
lter housing by hand.
Examine the o-ring
located at the top of the
lter housing. Replace
this O-ring every third
lter change to ensure
proper sealing.
Replace the old lter
element with a new one.
Thread the lter housing
back onto the lter
mount and hand tighten.
Reconnect water supply
and run water for 20
minutes to ush the
system.
040533b
040473c
040520c
040520c
Filter Wrench
040520d

Table of Contents