Beaver Contessa - Dryer Operation; Dryer Maintenance; Central Vacuum (Optional); Operation

109
20 08 CONTESSA
APPLIANCES — 4
Dryer Operation
Hook to shore power or start the generator to
operate the dryer.
WARNING:
DO NOT dry articles that have
previously been cleaned, washed, soaked
or spotted with gasoline, dry cleaning
solvents or other flammable or vaporous
substances that can ignite or explode.
CAUTION:
DO NOT use heat to dry articles
containing foam rubber or similar
textured, rubber-like materials. Clean
the lint screen, (located inside the
dryer) after each use. Keep the exhaust
opening and adjacent areas free from
accumulation of lint, dust and dirt.
To Operate the Dryer:
1. Load laundry loosely into dryer and
close the door. Allow space for the
clothes to tumble freely.
2. Turn the cycle control knob to the
recommended cycle for the type of
load being dried.
3. Push the START button.
4. Open the door, or turn the Cycle
Control Knob to OFF to stop the dryer.
Dryer Maintenance
Clean the lint screen after each load:
Open the door and pull the lint screen
straight out.
Squeeze body of lint screen slightly
while pulling off cover.
Roll lint off screen. DO NOT rinse or
wash screen to remove lint.
Replace cover on lint screen body. Push
the lint screen rmly back into place and
close the door.
CAUTION:
DO NOT run dryer with lint screen
loose, damaged, blocked or missing.
Doing so can cause overheating and
damage both the dryer and fabrics.
WARNING:
Never use flammable cleaners to clean
the any part of the dryer. Failure to
comply with this warning could result in
fire, explosion, injury, and/or death.




CENTRAL VACUUM (Optional)
Operation
Start generator or plug
into shore power.
Lift lid on wall receptacle
to start vacuum. Insert the
hose in the receptacle and
release lid.
Connect desired
attachment on hose and
start vacuuming.
NOTE:
Consult OEM manual for detailed
operation and maintenance.
Maintenance
Vacuum has a thermal protector built into the
motor to prevent overheating. If motor will not
operate, it will automatically reset in about ½
hour. If motor brushes or bearings are worn out,
the circuit protector will trip off again after a
short period of time. If this happens, contact a
qualied service representative.
Changing the Bag:
To keep your vacuum at top efciency,
change the lter bag at regular intervals. To
maintain cleanability, replace lter bag when it
is about ¾ full.



031104c
031264f
Wall Receptacle