EQUIPMENT — 5
126
20 08 CONTESSA
To Watch a DVD:
Insert a DVD into the Home Theater
System.
Turn on the TV. Press the Video button
(on TV) until the DVD menu displays.
Adjust the volume on the home theater
system or TV.
To Play a Music CD:
Press the desired Disc Open/Close button
(numbered 1-5 for each slot of the 5 disc
changer) on the Home Theater System.
Place a CD on the tray, label side up.
Press the Open/Close button. Press Play
if necessary.
Television – Bedroom
To Operate All Components:
Hook to shore power, start the generator
or turn on the inverter.
Use the battery cut-off switch to activate
the interior 12 Volt power.
NOTE:
Reading individual component owner’s
manuals is strongly recommended.
To Watch TV from Antenna/Shore Cable:
Turn on the TV. Press the Video button
until a channel number displays in the
upper right corner.
Select either Roof Antenna (On) or
Shore Cable (Off) on the Selector switch
in the front overhead cabinet.
Select channel.
To Watch a DVD (Optional DVD Player):
Turn on the DVD player. Press the
Open/Close button and insert DVD.
Turn on the TV. Press the Video button
until DVD menu displays.
Adjust sound to desired level.
SATELLITE PREP
The motorhome is pre-wired for a roof-
mounted or portable satellite system. The pre-
wire consists of a satellite receiver connection,
a 12 Volt DC power connection and a phone
cable for pay-per-view programming. These
connections are located in the front overhead
cabinet next to the home theater system.
SATELLITE (Optional)
The KVH R5 system includes an antenna and
a power switch panel with diagnostic port. The
KVH system powers the antenna and sends
the information to the receivers (not included),
which decode the satellite signal from the
antenna and send it to the television
NOTE:
Satellite service requires subscription
activation and additional hardware.
Contact your service provider to
activate the account.
NOTE:
For specific satellite coverage areas and
providers see the OEM manual.
Turning On the Antenna:
1. Turn on the KVH satellite system. Press
the power button on the KVH switch
panel located in a front overhead
cabinet.
2. Turn on the satellite receiver (not
included).
3. Wait 30 to 60 seconds for the antenna
to acquire the satellite signal.
4. Turn on the TV and press the Video
button on the top of the TV until the
Satellite screen displays.
5. It takes approximately one minute for
the receiver to download guide data.
Channels can be selected once the
guide is downloaded.
NOTE:
Inclement weather conditions may
adversely affect the satellite signal
acquisition. Degraded audio and video
signals through the receiver will result.
Maintenance:
Periodically clean the antenna dome with
water and mild soap if necessary. Do
not spray the dome or the roof with high
pressure water.
For assistance in operation or for
technical support call:
KVH Technical Support
1-401-847-3327
To Next Page
Loading...