107
20 08 CONTESSA
APPLIANCES — 4
2. Rotate Selector knob to a wash position
with the Wash Temp setting on Warm.
Press the power button to On. Air
pressure will clear the Hot and Cold
water lines.
3. After water lines are clear, rotate
Selector knob to Spin. Allow the pump
to drain the drum.
4. Set Selector knob to Reset and Timer
to zero. The door will unlock in two
minutes or less. Open door and pour in
¼ gallon of RV antifreeze.
5. Set selector knob to Spin. The pump
will prime with antifreeze. Set selector
knob to Reset and turn the power off.
WASHER (Optional)
The Whirlpool stackable washer is a large
capacity automatic washer.
The washer operates on 120 Volts AC
from shore power or generator power.
The washer uses between 16 and 35
gallons of water per load, depending on
cycles and water levels chosen, as well
as the volume of laundry.
CAUTION:
DO NOT use
the washer
while traveling
as damage will
occur to the
washer and
motorhome.
NOTE:
Due to the automatic appliance selector
prioritizing use of appliances to
prevent electrical overload, only one
of the following can be used at a time:
bedroom A/C or washer-dryer.
NOTE:
Monitor fresh water and grey water
tank levels when not hooked to city
water and/or sewer.
INFORMATION:
The washer has many features. Refer
to the manufacturer’s manual in the
owner’s information file for detailed
operating instructions.
Test Cycle
Run a test cycle before using the washer for
the rst time after a long period of non-use.
The test cycle will conrm the unit is working
correctly, remove RV antifreeze that may be
present and veries all hardware, plumbing and
electronic components are functioning.
Test Cycle Requirements:
Wipe the exterior and interior of the
unit with a damp cloth to remove
accumulated dust.
Make sure water lines are secure and all
the necessary supply valves are open to
supply water.
Hook to city water or turn on the water
pump (must have sufcient water in
fresh tank).
Hook to shore power, or turn on the
generator.
Conducting a Test Cycle:
Add ½ the laundry detergent for a
normal load to the pull-out dispenser.
Set the load selector Regular/Normal.
Push the power button followed by the
Start button.
Operating Instructions
Add a sorted load of laundry loosely into
the washer. Do not overload.
Close washer door.
Add detergent to the middle
compartment of the pull-out dispenser.
Chose the cycle that matches load
requirements. Water temperature is
automatically determined by load preset.
Select the appropriate spin cycle setting.
Push the Power button followed by the
Start button.
031017h
To Next Page
Loading...