CHASSIS INFORMATION — 10
218
20 08 CONTESSA
LEVELING - HYDRAULIC
The leveling system is designed to reduce
sight selection problems and stabilize the
motorhome when parked. The leveling system
features a remote control panel (located near the
pilot seat). The multiple warning system consists
of a Jacks Down LED and warning alarm if a
jack is down and the transmission is placed in
gear or the park brake is released. The leveling
system can be operated in manual or automatic
modes.
Safety Features:
The leveling system has safety features to
prevent a jack from extending during travel.
The control panel will not activate until the
following safety features are in place.
Transmission is in Neutral.
Parking brake is applied.
Ignition switch is in the ACC or On
position.
Control Panel:
The control panel includes four jack extend
switches, an Auto switch, a MAN (manual)
switch, a retract All Jacks switch and a power
ON/OFF switch. A LED light next to a
directional button indicates that position is low.
Indicator Lamps:
MAN – Indicates system is in manual
level mode.
AUTO – Initiates Automatic level mode.
ON/OFF – Turns the leveling system on
or off.
JACKS DOWN – Indicates one or more
jack is extended.
LOW VOLTAGE – Indicates chassis
voltage is low.
ENGAGE PARK BRAKE – Indicates
the Park Brake is disengaged.
The LED adjacent to any extend switch
indicates that position is low.
CAUTION:
The leveling jacks are not designed for
changing tires. Using the jacks to elevate
any wheel position off the ground will
cause problems with the suspension
system, frame alignment and damage to
the windshield(s).
CAUTION:
DO NOT move the motorhome while
the jacks are still in contact with the
ground or extended. Damage to the
jacks can occur.
To Next Page
Loading...