APPLIANCES — 4
110
20 08 CONTESSA
1. Unplug the power unit from grounded
outlet.
2. Rotate the bag cover counterclockwise
and remove cover.
3. With a nger on each side of the inlet,
slide the bag off the inlet tube.
4. Pull the center cardboard tab to
automatically seal the bag and prevent
dust from leaking out.
5. Remove the bag from the vacuum and
discard. DO NOT reuse.
6. Check motor lter in back of canister.
7. Unfold the new bag and insert into the
vacuum so the center cardboard seal
tab is toward bag cover. The top arrow
should point to the bag cover.
8. With a nger on each of the cardboard
tabs, slide the bag on the inlet tube.
9. Line up the mark on the bag cover with
the unlock symbol and rotate clockwise
to lock symbol.
Replacing & Cleaning the Motor Filter:
1. Inspect during each bag change. The
lter should be cleaned every fth bag
replacement or when excessively dry.
2. Remove dust bag as previously
instructed.
3. Locate the motor lter in the back of
the vacuum and lift out.
4. Clean by rinsing under warm water
and let air dry if heavily soiled. If the
lter is torn or obstructed it must be
replaced.
5. Reinstall dry motor lter before use,
making sure lter is tucked under
retaining tabs.
6. Reinstall bag as previously instructed.
WARNING:
To reduce the risk of fire, electric shock
or injury:
Unplug and disconnect power
before servicing.
Avoid wet surfaces.
Use only manufacturer’s
recommended attachments.
DO NOT use without dust bag and/
or lters in place.
DO NOT pick up anything that
is burning or smoking, such as
cigarettes, matches, or hot ashes.
Use extra care when cleaning on
stairs.
DO NOT use to pick up ammable
or combustible liquids such as
gasoline or use in areas where they
may be present.
031264
Counterclockwise to
unlock for removal.
Clockwise to lock.
031264d
Ensure the bag seal
is secure over the
inlet tube.
031264c
Motor Filter: Check
before replacing bag.
031264e
To Next Page