Standard-Messages
Multi axis servo system - AX8000 27
Version: 1.1
3.13 5593, Structure Version is incompatible to this
Firmware
Detected incompatible Pcb for this Firmware.
- ID 0: ControlPcb
- ID 1: FrontPcb
- ID 2: AdditionalAxisPcb
- ID 3: DisplayPcb
- ID 6: SafetyPcb
- ID 7: CpuPcb
Diagnostic Code (Hex.) Diagnostic Code (Dez.)
5593 21907
Class Type
Error Error
Standard Reaction Reset
Torque off A reset is not possible. The drive detected a fatal
hard- or software error.
Possible Causes Solutions
This Hardware needs a newer Firmware. Ask the Beckhoff branch office that is responsible for
you for the right Firmwareversion.
Internal: 0x5593, ESC EEPROM Pcb ID %u Structure Version is incompatible to this Firmware.
To Next Page
General
